people don’t remember which email they signed up with

No. We are the top 5%-10% of users

I’m still creating local accounts using the bypass in the auto unattend file.

If a drive is crypto locked and there is only a local account, it might as well be wiped if nobody has a password.

Step one, be forced to create a Microsoft account.

Step two, create the account with a password you are SURE you remember

Step three, create a PIN so you never have to enter your password

Step four, forget your password

If I have to guess, it looks like compression. Either you are over extruding or your print head is too close.

It’s hard to separate the trash from the talk. I only got so far on that thread. Can anyone give a quick answer why they hate 4chan?

Microwaving the iphone was close to the right answer.

The most important change was going from pewpewpew to pop pop.

To be clear, that was the BEST run, when it wasn’t attempting to email the FBI or the fundamental laws of the universe.

Aruba isn’t bad. The CLI isn’t too divergent from Cisco. You don’t have the proprietary stuff, though.

Reads like an ad for Bamboo 3D printers.

Annual revenue of over 250bn

If their income was based on a 40 hour work week, they would be making a billion daily.

That would mean that they paid the equivalent of an hour’s worth of pay to settle an old argument.

Edit, unclear.

It’s a bad relationship souring further. This is the point where we say that it’s time to break it off.

As in a reasonable replacement to Tesla home batteries?

Had a couple affected. Only user to be upset was someone who prints checks. Moved the printer to Ethernet instead of USB. It was no longer an issue.

Problem happened every time the printer reconnected to the computer, which happens several times an hour because HP printers don’t stay sleeping.

This problem has been brewing off and on for a few months. This is the first time I have seen it with symbols.

Enterprise equipment is durable.

Consumer laptops fall apart.

What if me make a heat laser? /s

For grinding, try calibrating with a calibration cube and calipers.

For the stringing, try calibrating your extrusion steps. If it continues, try dialing back your temp 5° at time.

There is a process for retracting slightly between hops, but that may be a slicing option.

I was going to press you on the firmware for the CPU, but I was unaware that CPU microcode exists and is built to live in the cache.

Oh, then OP will most likely need to replace their hardware with something like Framework, as I can’t see x86-64 becoming open.

Baby steps are okay too.